The Groups Of The Medical Syringes And Needles A Health Practitioner Can Access In The Business Market Today
The medical section and the apparatus used in injecting are an inseparable pair that is fully dependent on each other hence one can never work without the other. Just like the one man’s meat is another man’s poison approach, one tool can never be suitable for all cases hence the choice made should be perfect for each the situation. Depending on the amount and type of medication to be offered to a patient and the mode of delivery a medical expert will always go for the most suitable type of syringe and needle to make the procedure most effective and with minimal pain and drawbacks. It is only fair to go for the most appropriate needle and syringe for any particular medical administration and their compatibility tested and proven too.
The medical syringes are classified into two broad classes according to the type of tips they come with which are the Luer -Lok which are the type that calls for tips that need needles which have to be twisted and locked into position for effective to minimize the chances of accidental slipping off of the syringe. The two groups are a total contrast to each other such that while one calls for twisting and locking of the tip, the other does not.
There is another set of syringe classification that results from the type of fluid the syringe is suitable to deliver into the patient’s body. The first in this class is they insulin syringe which is not only petite in size but also has a volume of between not less than 0.3 ml and not more than 1 ml. This group of syringes is unique from the rest following the units they used in the calibration which are units. A good number of these syringes are marked up to 100 units and are best designed for self-medication and injection as well as for subcutaneous injections.
The syringes are suitable anytime one has to be tested for TB. They are marked in milliliters just like all the others with a long pre-attached needle which is thin and barreled in nature. Their volume is approximately 1 ml and also small in size but should never be used for insulin administration.
Most medical needles available in the business market are manufactured from stainless steel. The needles have to be hollow and with a small hole in the middle for ease of flow of the fluid or medication. They are made up of three parts namely the hub, shaft and the bevel.
The classification of needles is done based on their distance end to end and the distance all around. While the length never goes below 0.3 inches, and above 3 inches, a large diameter means a small gauge and vice versa. The the diameter of a needle varies between 7 gauges, and 33 gauges and highly viscous fluids require tiny gauged needles.